|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Decreasing thrust of a trolling motor
On Sunday, May 16, 1999 at 12:00:00 AM UTC-7, Jon Stewart wrote:
I have an unusual problem with my trolling motor - it's too powerful. I
have a 12' aluminum John boat and bought a 30 lb thrust12 V Minn-Kota.
Nice motor, but even on the slowest setting it moves the boat too fast,
especially for plastic worm fishing. Using the reverse setting (and
turning around the motor) works a little better, but it's still too fast
unless the wind is very strong. What I would like to do is cut the
speed by a factor of 2 or 3 on all settings. I had thought about
cutting off part of each prop blade to decrease the efficiency. Any
HOW ABOUT BUYING SMALLER PROP OR CUTTING THE EDGES OF YOUR PROP.
THAT IA WHAT I WILL DO.
HAVE SIMILAR PROBLEM
|Thread||Thread Starter||Forum||Replies||Last Post|
|109 lb Thrust Trolling Mtrs !||Joshuall||Bass Fishing||2||December 21st, 2007 03:19 PM|
|trolling motor||fishtale||Bass Fishing||19||November 2nd, 2007 12:40 AM|
|Trolling motor help||BIG FISH 2006||Bass Fishing||0||March 29th, 2006 02:01 AM|
|Motor Guide trolling motor||IBNFSHN||Bass Fishing||0||February 16th, 2005 03:59 PM|