|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 25th, 2004, 09:09 PM
|
|||
|
|||
gunwale rod holders
If I stick some rod holders in my horizontal gunwale surface, what's an easy
and inexpensive way to plug 'em when not in use so minimal water gets in and through to the bilge??? Anybody have special molded rubbed/plastic plugs for that purpose? 
|
|
#2
July 26th, 2004, 03:16 AM
|
|||
|
|||
|
gunwale rod holders
I'm not sure what you need, but www.caplugs.com has lots of different
kinds of plastic plugs for industrial use. Regards, Cliff Fishing: "a sport surrounded entirely by liars in old clothes"
|
|
#3
July 26th, 2004, 03:16 AM
|
|||
|
|||
|
gunwale rod holders
I'm not sure what you need, but www.caplugs.com has lots of different
kinds of plastic plugs for industrial use. Regards, Cliff Fishing: "a sport surrounded entirely by liars in old clothes"
|
|
#4
July 26th, 2004, 03:16 AM
|
|||
|
|||
|
gunwale rod holders
I'm not sure what you need, but www.caplugs.com has lots of different
kinds of plastic plugs for industrial use. Regards, Cliff Fishing: "a sport surrounded entirely by liars in old clothes"
|
|
#5
July 26th, 2004, 04:31 AM
|
|||
|
|||
|
gunwale rod holders
Wonderful, Cliff. Thanks. That should to it!
|
|
#6
July 26th, 2004, 04:31 AM
|
|||
|
|||
|
gunwale rod holders
Wonderful, Cliff. Thanks. That should to it!
|
|
#7
July 26th, 2004, 04:31 AM
|
|||
|
|||
|
gunwale rod holders
Wonderful, Cliff. Thanks. That should to it!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEW - Two Scotty Powerlock Rod Holders | talk_to_god2000 | General Discussion | 1 | January 30th, 2004 03:22 PM |
Linear Mode
