If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
How to tell ice thickness
Well wear a pfd anyways!
"Steve Ward" wrote in message newsJHLb.38809$ts4.35865@pd7tw3no... NEVER EVER use chest waders for ice fishing. If the ice broke you would drown Steve "Dre" wrote in message ... Chest waders?? Isn't that the worst thing you can do? If the ice breaks and your chest waders fill up with water then you'll sink right to the bottom. Dre "Marc" wrote in message .. . Well be careful & wear your chest waders & PFD! Glub! Glub! LOL "SC" wrote in message ... Well, I never realised there was so much to it. Thank you both for your interesting and detailed replies :-) It will be my first time ice fishing at my cottage and I intend to go on 16th February in Nova Scotia. I will post the group to let you know how I get on. Thanks again ARB "smiles" wrote in message ... The only effective method of measuring ice thickness is by cutting a hole. 4 inches of solid ice is ample for someone to walk on. It will take a couple of good whacks with an axe to cut through. If I can sink the blade of my axe through the ice with one whack, it's a bit too thin for my liking. If you plan to do the occasional fishing, you can make a cutter out of a long pole of metal and you can weld a square piece of metal to the end. You sharpen the square piece and hack a hole through the ice. It will cost you about 20 to 25 bucks to have one made at a welding shop. The width of the cutter should be about 2 1/2 to 3 inches wide. If you are going to go ice fishing more often and if the ice gets over 1 foot thick, an ice auger is the way to go. A manual ice auger to make 8 inch diameter holes will cost about 60 bucks. The cutters are very fragile. Any sand, or getting knocked about will prevent any further cutting until the cutters are sharpened. They should be as sharp as razors. When very sharp, the auger will go through the ice very quickly and easily. Occasionally, the cutters must be carefully honed otherwise you will have to buy new ones for about 20 bucks. I carefully hone mine (keep the original angle of cut perfect) and they get sharp enough to shave the hair on my forearm. There are 6 inch diameter augers and they are a tad less expensive. They are also fine if you fish in an area that is not really cold and the fish are not big. A rather large fish can go through a 6 inch hole but when it gets really cold, the holes have a tendency to freeze up and get smaller. In -15 to -25 weather, a 6 inch hole really freezes up fast. But....cutting a hole through ice is a bit easier with a 6 inch auger. Some people who do a lot of ice fishing, most guides, all outfitters, use gas operated augers. They cost about 350 dollars. When using one where there are many fishermen, you can offer to cut holes for a small fee. By the end of 2 years, your machine could have paid for itself. But, you will have to haul smelly gas, the extra weight and if the auger is not maintained, it could give you problems. Manual augers always start. "SC" wrote in message ... Hi everyone. On the subject of ice fishing, can anyone tell me a cheap way to measure the ice thickness without buying one of those ice drill things? I have bought a house by quite a shallow lake, so could I carefully step out and hack a hole with an axe and does the ice get thicker the further out you go? Thanks a lot in advance. ARB |
#12
|
|||
|
|||
How to tell ice thickness
Actually....chest waders full of water and chest waders not full of water
weigh the same in the water. You will not sink to the bottom any faster if the waders are full of water. What will help is the amount of air trapped inside the waders so it stands to reason that if the waders are full of water there will be no trapped air inside the waders. A good solid belt to hold the air inside the waders will help to float a fisherman. Too much air and I would guess that the fisherman could float "head down" in the water but a personal floatation device would help to keep the fisherman's head out of the water. With trapped air in the waders and a PFD, a floating fisherman could even become a good device to sit on and fish from. "Dre" wrote in message ... Chest waders?? Isn't that the worst thing you can do? If the ice breaks and your chest waders fill up with water then you'll sink right to the bottom. Dre |
#13
|
|||
|
|||
How to tell ice thickness
That's cold Smiles...real cold...
DK "smiles" wrote in message . .. Actually....chest waders full of water and chest waders not full of water weigh the same in the water. You will not sink to the bottom any faster if the waders are full of water. What will help is the amount of air trapped inside the waders so it stands to reason that if the waders are full of water there will be no trapped air inside the waders. A good solid belt to hold the air inside the waders will help to float a fisherman. Too much air and I would guess that the fisherman could float "head down" in the water but a personal floatation device would help to keep the fisherman's head out of the water. With trapped air in the waders and a PFD, a floating fisherman could even become a good device to sit on and fish from. "Dre" wrote in message ... Chest waders?? Isn't that the worst thing you can do? If the ice breaks and your chest waders fill up with water then you'll sink right to the bottom. Dre |
#14
|
|||
|
|||
How to tell ice thickness
They may not weigh more IN the water but try to get OUT of the water with
waders full of water!! It's not drowning that you need to worry about, as much as hypothermia. You need to get out of the water as fast as possible, then get warm and dry ASAP. Every bit of saftey advice I've seen, says never wear waders or hip boots when ice fishing. You want clothes as light as possible (while still heavy enough to stay warm). -- Schmidty "Dark Knight" wrote in message ... That's cold Smiles...real cold... DK "smiles" wrote in message . .. Actually....chest waders full of water and chest waders not full of water weigh the same in the water. You will not sink to the bottom any faster if the waders are full of water. What will help is the amount of air trapped inside the waders so it stands to reason that if the waders are full of water there will be no trapped air inside the waders. A good solid belt to hold the air inside the waders will help to float a fisherman. Too much air and I would guess that the fisherman could float "head down" in the water but a personal floatation device would help to keep the fisherman's head out of the water. With trapped air in the waders and a PFD, a floating fisherman could even become a good device to sit on and fish from. "Dre" wrote in message ... Chest waders?? Isn't that the worst thing you can do? If the ice breaks and your chest waders fill up with water then you'll sink right to the bottom. Dre |
|
Thread Tools | |
Display Modes | |
|
|