View Single Post
  #17  
Old February 25th, 2004, 01:30 AM
\The Shadow\
external usenet poster
 
Posts: n/a
Default 7' baitcasting rod... action

Vincent, two reputable rodbuilders have tried to answer your questions here.
Sometimes you have to go with the flow and trust those around you. I will
add this final comment. Trust your gut reaction, I bet you won't be wrong.

--
Dave Norton
"The Shadow"
Millennium Rods
"Vincent." wrote in message
...
Hi :-) ,

In describing actions of rods, it goes like this. Extra Fast has the

most
backbone in a rod, but the least "tip action." With rods like this,
probably just the last 15% of the rod will bend easily, with increasing
stiffness as you go toward the butt of the rod. This rod will have the
fastest hooksets.



Ok... just like my two Garbolino...


A Fast Action rod will have a lot of backbone, but more of the tip

section
will bend, probably in the neighborhood of 20-25% of the tip end of the

rod.

The one y need to complete my rod storage... :-)


In a Moderate Action rod, almost half of the rod will bend fairly

easily.
This type of rod is preferred by many for fishing spinnerbaits and
crankbaits. This rod will have a slower hookset, but that's preferred

by
many to avoid setting too soon.


Like my Diaflash...


A Soft Action rod is preferred by many live bait anglers and salmon

anglers
when they want a rod that has lots of give, This type of rod makes it

more
difficult to snap off live bait when casting or tear hooks free from

soft
mouthed fish like salmon.


Like my Beast Master... but I hate it... I don't fill anything with it...
:-s


What you need to figure out is what weight lures you're going to be

throwing
and your fishing style. You need a rod that is going to have the proper
"give", in order to work the lure properly. If you're having difficulty
working a lure, it could be the action, but it could be that you're

using
rods that are meant for heavier lures than you're using. If the lure is

too
light, it's not going to load up the rod for the desired flex in order

to
work the lure either.


I know this... this is ones in others that makes fishing so expensive...

:-)


From what I can figure out, and looking at the rods listed, the Shimano
Compre will do a good job for you, but all of your suggestions seem a

bit
on
the heavy side for fishing soft plastic jerkbaits and topwater lures.
--
Steve @ OutdoorFrontiers


Thanks... ;-)
I hope to be abble to try some compre or others at the futur show arround
here... if not, my last choise will be to order it in USA... but I don't
like to buy a rod without having it in hand before... :-s

Vincent.