![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Vincent, two reputable rodbuilders have tried to answer your questions here.
Sometimes you have to go with the flow and trust those around you. I will add this final comment. Trust your gut reaction, I bet you won't be wrong. -- Dave Norton "The Shadow" Millennium Rods "Vincent." wrote in message ... Hi :-) , In describing actions of rods, it goes like this. Extra Fast has the most backbone in a rod, but the least "tip action." With rods like this, probably just the last 15% of the rod will bend easily, with increasing stiffness as you go toward the butt of the rod. This rod will have the fastest hooksets. Ok... just like my two Garbolino... A Fast Action rod will have a lot of backbone, but more of the tip section will bend, probably in the neighborhood of 20-25% of the tip end of the rod. The one y need to complete my rod storage... :-) In a Moderate Action rod, almost half of the rod will bend fairly easily. This type of rod is preferred by many for fishing spinnerbaits and crankbaits. This rod will have a slower hookset, but that's preferred by many to avoid setting too soon. Like my Diaflash... A Soft Action rod is preferred by many live bait anglers and salmon anglers when they want a rod that has lots of give, This type of rod makes it more difficult to snap off live bait when casting or tear hooks free from soft mouthed fish like salmon. Like my Beast Master... but I hate it... I don't fill anything with it... :-s What you need to figure out is what weight lures you're going to be throwing and your fishing style. You need a rod that is going to have the proper "give", in order to work the lure properly. If you're having difficulty working a lure, it could be the action, but it could be that you're using rods that are meant for heavier lures than you're using. If the lure is too light, it's not going to load up the rod for the desired flex in order to work the lure either. I know this... this is ones in others that makes fishing so expensive... :-) From what I can figure out, and looking at the rods listed, the Shimano Compre will do a good job for you, but all of your suggestions seem a bit on the heavy side for fishing soft plastic jerkbaits and topwater lures. -- Steve @ OutdoorFrontiers Thanks... ;-) I hope to be abble to try some compre or others at the futur show arround here... if not, my last choise will be to order it in USA... but I don't like to buy a rod without having it in hand before... :-s Vincent. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
baitcasting brake | Philtix | General Discussion | 1 | May 26th, 2004 05:46 AM |
FS: Diawa CV-X253A baitcasting reel | Glenn Ziolkowski | General Discussion | 0 | February 26th, 2004 02:55 AM |
HELP..Baitcasting reels | Dene Gatlin | Bass Fishing | 7 | November 22nd, 2003 10:20 PM |
Baitcashing Handedness results | Rich Conley | Bass Fishing | 1 | September 22nd, 2003 06:40 PM |
Baitcasting handed-ness | G. M. Zimmermann | Bass Fishing | 1 | September 22nd, 2003 03:15 AM |