|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 19th, 2006, 04:02 PM
posted to rec.outdoors.fishing.bass
|
|||
|
|||
trim tab question
I notice that most of the trim tabs for an 18' boat size range are 9x12",
with a few even wider. Why not smaller? Is it that smaller than this would not give enough lift in all situations? I want to be sure and get enough lift, but I also don't want to go wider than necessary on the transom. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| parachute worth question...... | Sandy Pittendrigh | Fly Fishing Tying | 13 | April 17th, 2006 03:31 PM |
| Hello again, and I've got a tiring question | SteptInSomethin | Bass Fishing | 7 | May 11th, 2005 03:19 AM |
| Yammy Trim Switch Failure | Bill Durham | Bass Fishing | 9 | February 13th, 2005 02:59 AM |
| Sonar Question | Joshuall | Bass Fishing | 7 | February 8th, 2005 11:15 AM |
| Tournament Question | Chuck Coger | Bass Fishing | 7 | October 1st, 2003 10:48 PM |
Linear Mode
