|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
April 8th, 2005, 03:55 PM
|
|||
|
|||
"Tim J." wrote in message ... I just stuck the word "flyfishing" in there so it would be on-topic. ;-) Okay all you roffian canoers, here's the plan: My canoe has two seats at front and rear with a gunwale in the center. Can I remove the center gunwale and replace it with a solid, mounted seat for solo ventures, or will that screw up the structural integrity of the canoe? Depends on how good you are with tools. The fact that you plan to remove the "center gunwale" rather then the thwart that is presumably there bodes ill.  Wolfgang 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Idea for aligning canoe on stream. | CR | Bass Fishing | 9 | March 16th, 2004 09:20 PM |
| FA: 2hp motor and/or Canoe in Baltimore, MD -- ending Wed. | Marty S. | General Discussion | 1 | March 15th, 2004 09:50 PM |
| FA: 2hp motor and/or Canoe in Baltimore, MD -- ending Wed. | Marty S. | Bass Fishing | 1 | March 15th, 2004 09:50 PM |
| Canoe...Fishfinder...Am I crazy? | Rich Conley | Bass Fishing | 6 | March 3rd, 2004 03:45 AM |
| FS: Canoe in Baltimore -- YOUR Xmas present? | Marty S. | General Discussion | 0 | December 20th, 2003 12:13 PM |
Threaded Mode