![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
![]()
On Tue, 30 Jun 2009 18:20:55 -0600, rw
wrote: Dave LaCourse wrote: A guide dreamed up the bead method. You slip a colored glass bead onto the end of your leader (represents the egg/spawn and can be colored with finger nail polish to match whatever salmon pattern you are targeting). Forget about the fingernail polish. Visit http://www.troutbeads.com/. Actually the fingernail polish is still used. You start out with a solid colored bead and either lighten or darken it depending upon the eggs in the stream you are fishing. None of the beads I have fished with were a solid color, but have their color altered in some way with finger nail polish. Some of the guides were very picky about how the color should be altered. You then tie a short piece of tippet to you leader (double surgeon's knot is fine), slide the bead down to the knot and hold it there by placing a tooth pick in the bead (and breaking off the tooth pick's end). You then tie a hook onto the other end (four to five inches) of the tippet. The extra tippet and knot aren't necessary. The toothpick works just fine by itself. Stick it in the hole, clip it off with your nippers (you need sharp nippers) and jam the remainder down into the bead with your forceps. It helps to treat the toothpicks ahead of time with rubber cement. BTW, Dave, ADFG Bristol Bay Alaska regulations require the bead to be either free-floating or no more than two inches from the hook. If you were fishing in Bristol Bay with a bead four or five inches from the hook you were breaking the law. We weren't breaking the law. The hook was very close to the bead, probably less than two inches. I used four or five when I tried it with the sucker spawn. I found the knot useful in stoping the bead from slipping. You see the take when the rainbow hits the bead, set the hook which pulls the bead out of the fish's mouth and brings the hook into the mouth. Voila! Big rainbow on an egg pattern with the hook in its upper jaw. Its an extremely effective technique, not only for rainbows, but also for char and grayling. Some people call it snagging. True. I took dozens of very large Dollies with the method, and of course, the damned grayling. I don't think it's much different from fishing two or more nymphs. Often, the fish will take the top nymph, you'll miss the hook set, and you'll "snag" the fish, often on the outside of the mouth, with the bottom nymph. I usually tie on a glow bug instead of a bare hook. Or a PT. Moffit would never come close to the fly du jur. I won't use it again on the Rapid. It seems ok by me to use it in Alaska, but I got the feeling that I was snagging those big brookies and landlocks on the Rapid. Heading back up there in the morning with lots of soft hackle stuff. River is running high, so fishing will probably be off. Dave |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Our legal system: | rw | Fly Fishing | 0 | December 11th, 2005 10:33 PM |
System One reel | Bob | Fly Fishing | 4 | November 20th, 2005 01:29 AM |
Gps system | Peter Kinsella | UK Sea Fishing | 7 | January 31st, 2004 12:40 AM |
Charging System | big fish 2003 | Bass Fishing | 0 | October 10th, 2003 12:23 AM |