![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Jerry Barton (NervisRek)" wrote in message
... There is a recirc pump available thru BPS and other places that attach to the bottom of your tank for inlet, and attaches to the top of your tank for an outlet, just be sure to put a screen at the bottom so you don't suck your fish into it like a vacuum hose. You can use any small volume pump to achieve the same results. But that would prevent the well from draining and also remove the ability to pump in water from the lake. I'd still need that value in order to keep that ability. |
#2
|
|||
|
|||
![]()
You hook it up as an extra pump to recirc only, with a seperate switch,
leaving the refill pump to it's own process. "Todd Copeland" wrote in message k.net... "Jerry Barton (NervisRek)" wrote in message ... There is a recirc pump available thru BPS and other places that attach to the bottom of your tank for inlet, and attaches to the top of your tank for an outlet, just be sure to put a screen at the bottom so you don't suck your fish into it like a vacuum hose. You can use any small volume pump to achieve the same results. But that would prevent the well from draining and also remove the ability to pump in water from the lake. I'd still need that value in order to keep that ability. |
#3
|
|||
|
|||
![]()
"Jerry Barton (NervisRek)" wrote in message
... You hook it up as an extra pump to recirc only, with a seperate switch, leaving the refill pump to it's own process. "Todd Copeland" wrote in message But that would prevent the well from draining and also remove the ability to pump in water from the lake. I'd still need that value in order to keep that ability. If I connected the drain to the recirculating pump and the recirculating pump to the fill value, there would be no drain to empty the livewell. I think I'm going to do this but I will need to install the value mentioned he http://www.flow-rite.com/marine/poa.html I think that is my best bet. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Another ??? for Pat our Resident Setup Man | Bob La Londe | Bass Fishing | 16 | April 26th, 2005 10:40 PM |
Advice on flipping/pitching rod & reel setup | Jesse | Bass Fishing | 13 | January 31st, 2005 03:19 AM |
Livewell working intermittently | Chip | Bass Fishing | 9 | June 7th, 2004 11:00 PM |
Spinning setup | Bucket Mouth | Bass Fishing | 18 | May 31st, 2004 06:10 AM |
Livewell Pump Questiom | Chuck Coger | Bass Fishing | 2 | September 25th, 2003 03:22 AM |