|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 20th, 2004, 11:16 PM
|
|||
|
|||
OK, I'm new here, and this subject has probably been beatentod...
Not at all resistant to pikes teeth. Try cutting it with a sharp knife, if
you can, the pike can cut it as well, because its teeth have got razor sharp edges. If you're serious about pike fishing you need a steel leader or a "hard mono" type leader of at least 60#, steel being safer and first choice in most applications. 
|
|
#2
April 21st, 2004, 02:32 AM
|
|||
|
|||
|
OK, I'm new here, and this subject has probably beenbeatentod...
If you're serious about pike fishing you need a steel leader or a "hard
mono" type leader of at least 60#, steel being safer and first choice in most applications I even use steel leaders for pickerel. Lost one too many raunchers with just regular mono.
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
