![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Robert11 wrote:
Hello: Have a question re DEET. A bit worried about the 100% deet, as I read in several places over the years that at this strength it is a carcinogen and should be avoided. True ? Not sure. Canada no longer supports sales of 100% DEET products. This is because of rapide absortion of DEET across the skin. Dropping down in strengths, I see iall the products seem to go from the 100% to 30% for several 3M offerings. Doesn't seem to be anything between 100% and 30%, surprisingly. Is the 30 % "fairly" effective ? Data suggets about 6 hours of repellency, but repellency is a relative term, just means fewer bites than if you didn't use the product. Apparently, 2 separate doses of 25% DEET provide prtection fo rthe same length of time as a single dose of 100% DEET, with half the prodcut. How dangerous is this stuff per any recent research ? Any other repellents "worth" trying ? Thanks, Bob See the information at http://www.pmra-arla.gc.ca/english/c...ellents-e.html . Also, the page http://www.pmra-arla.gc.ca/english/c...osquito-e.html provides a link to a safety evaluation of DEET. Tim Lysyk |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
My new Boat - Questions | Todd Copeland | Bass Fishing | 5 | April 8th, 2005 03:31 PM |
A Few Dropshot Questions... | Jim Jr. | Bass Fishing | 6 | October 19th, 2004 04:14 AM |
Sears Gamefisher 5HP engine questions... | GeneS | Bass Fishing | 0 | August 23rd, 2004 10:30 PM |
Questions About Timing (Tides, Moon, Weather, Etc.) - South Carolina Pier Fishing | Stanley M. Shepp | Saltwater Fishing | 2 | June 25th, 2004 07:02 PM |
San Juan questions | riverman | Fly Fishing | 6 | December 15th, 2003 11:36 AM |