|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 22nd, 2005, 06:12 AM
|
|||
|
|||
www.rodbuilding.org is the best forum site on the planet for rodbuilding.
Just wrap the guides on and then align them. Real simple way is the align the tip top so that the blank splits the ring in half, than do the same with the other guides. Works best highlighted against a light colored wall or something. This will give you a straight guide set even if the blank has a slight bend someplace, trying to get a straight set sighting down them from the top, especially if you have a slight dip in the blank, is a nightmare. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building structure | alwaysfishking | Bass Fishing | 16 | August 16th, 2005 08:26 PM |
| Rod Building? | Scott Seidman | Fly Fishing Tying | 4 | March 11th, 2005 08:55 PM |
| New rod building resource Discounts on g.loomis, sage, St.Croix etc | bobdobbins | Fly Fishing | 3 | August 16th, 2004 12:57 PM |
| Rod Building | Jim | Saltwater Fishing | 1 | January 18th, 2004 01:57 AM |
| rod building | Steve @ OutdoorFrontiers | General Discussion | 3 | November 28th, 2003 05:55 AM |
Hybrid Mode
