anchor question...>>>

"Marty S." wrote in message
...
Steve.... you recommend this type (the river anchor) over the grapneling
hook or the "Navy" style?

You've got what? A 12-14 (maybe 16 foot) aluminum boat??? Unless you're
fishing in some serious current and/or wind, a 12-15 pound River anchor will
give all the hold you're going to need. I was using this same style of
anchor (the 15 pound model) to hold a 17 foot glass boat and it worked well
in all but the hardest wind.

The thing to remember is to get the anchor tipped on it's side and to let
out enough anchor rope. There's more to anchoring a boat than dropping the
thing over the side and expecting it to hold. Figure to let out at least
twice the water depth in anchor rope in order to get it to hold properly.
This will get the anchor on it's side and the flukes dug into the bottom.

Make sure you've got enough quality rope, I use 75 or 100 feet (can't
remember which exactly) and it's good rope, not hemp and not braided nylon
ski rope. This is a 1/2" or 5/8" static kernmantle type rope, easy on the
hands and no stretch.

I don't like the Danforth style anchor because they can REALLY dig in and be
difficult to remove. And, in rocky bottoms, chances are, it'll stay there.
I went through three of them before I went to the River Anchor. Now, I
carry one of those (20 pound model) and a Richter Anchor
http://www.richteranchors.com/ and my boat doesn't move. The Richter is
great, but not readily available, where you should be able to get a River
Anchor at Wal-Mart.
--
Steve @ OutdoorFrontiers
http://www.outdoorfrontiers.com
G & S Guide Service and Custom Rods
http://www.herefishyfishy.com

Thank you, thank you, thank you for this link!!!
I saw this anchor in SOMETHING in print several years ago, catalogue or
magazine article, and promptly lost it, and could not remember the name. My
dad has an OMC/Grumman 16' aluminum that gives us both fits sometimes
getting it to hold at anchor in the wind, and when I saw the picture of this
anchor I knew that it would probably be the answer that we were looking for.

Hmm....
Gonna go and be sneaky on him. Order one and get it put on his boat while he
is out of town for the next two weeks. Hehe :-)

Thanx again
Cast far
Bob

"Steve @ OutdoorFrontiers" wrote in
message ...
snip
I went through three of them before I went to the River Anchor. Now, I
carry one of those (20 pound model) and a Richter Anchor
http://www.richteranchors.com/ and my boat doesn't move. The Richter is
great, but not readily available, where you should be able to get a River
Anchor at Wal-Mart.
--
Steve @ OutdoorFrontiers
http://www.outdoorfrontiers.com
G & S Guide Service and Custom Rods
http://www.herefishyfishy.com

"Bob" wrote in message news:220xc.54657$3x.53596@attbi_s54...
Thank you, thank you, thank you for this link!!!
I saw this anchor in SOMETHING in print several years ago, catalogue or
magazine article, and promptly lost it, and could not remember the name. My
dad has an OMC/Grumman 16' aluminum that gives us both fits sometimes
getting it to hold at anchor in the wind, and when I saw the picture of this
anchor I knew that it would probably be the answer that we were looking for.

Hmm....
Gonna go and be sneaky on him. Order one and get it put on his boat while he
is out of town for the next two weeks. Hehe :-)

LOL, you are a devious rascal. Can you talk to my kids about sneaking fishing stuff into my boat?


Glad you could use the link.
--
Steve
OutdoorFrontiers
http://www.outdoorfrontiers.com
G & S Guide Service and Custom Rods
http://www.herefishyfishy.com

"Steve @ OutdoorFrontiers" wrote in message
...

"Bob" wrote in message
news:220xc.54657$3x.53596@attbi_s54...

Hmm....
Gonna go and be sneaky on him. Order one and get it put on his boat
while he
is out of town for the next two weeks. Hehe :-)

LOL, you are a devious rascal. Can you talk to my kids about sneaking
fishing stuff into my boat?


Glad you could use the link.
--

Right, sure thing. Once I learn how to do it. Can't get me own
flesh-'n-blood to sneak stuff in for me, and I have been working on him for
12 years now. But as soon as I figure out how to talk him into doing this, I
will come up and tackle your kids for you ;-)

Bob

On Mon, 07 Jun 2004 15:42:54 GMT, "Bob" wrote:
My
dad has an OMC/Grumman 16' aluminum that gives us both fits sometimes
getting it to hold at anchor in the wind, and when I saw the picture of this
anchor I knew that it would probably be the answer that we were looking for.

===========================================

The key to getting ANY anchor to hold is sufficient scope (ratio of
anchor line to water depth). 7 to 1 is considered ideal, 5 to 1 will
usually suffice. Also use a 3 or 4 foot length of chain as others
have mentioned. The implication is that if you are anchoring in 30
feet of water, you need between 150 and 200 feet of line. Many small
fishing boats do not carry that much. I've found that a mid-sized
canvas tote bag will hold 200 feet of 3/8 line, and the anchor. Just
lay the line into the bag, do not coil, and it will pay out with no
snarling or kinking.

"Wayne.B" wrote in message
...

The key to getting ANY anchor to hold is sufficient scope (ratio of
anchor line to water depth). 7 to 1 is considered ideal, 5 to 1 will
usually suffice. Also use a 3 or 4 foot length of chain as others
have mentioned. The implication is that if you are anchoring in 30
feet of water, you need between 150 and 200 feet of line. Many small
fishing boats do not carry that much. I've found that a mid-sized
canvas tote bag will hold 200 feet of 3/8 line, and the anchor. Just
lay the line into the bag, do not coil, and it will pay out with no
snarling or kinking.


The real problem is trying to get dear old dad to think like this. He is
rather set in his ways, but this is to be expected as he is now 70! He keeps
thinking about anchoring to fish a spot the same way he used to do it with a
little 14' aluminum row boat. And rather than argue with him, I just want to
get him an anchor that may work better with his 16' and the way that he
wants to use it.

Cast far
Bob

Wayne.B wrote:

The key to getting ANY anchor to hold is sufficient scope (ratio of
anchor line to water depth). 7 to 1 is considered ideal, 5 to 1 will
usually suffice. Also use a 3 or 4 foot length of chain as others
have mentioned.

Took me a long time to realize what you are saying. Most people don't
realize the amount of rope required to hold a boat properly regardless
of anchor type.



I've found that a mid-sized
canvas tote bag will hold 200 feet of 3/8 line, and the anchor. Just
lay the line into the bag, do not coil, and it will pay out with no
snarling or kinking.


I'll have to give this a try. Nothing drives me crazy as fast as a
knotted up rope when trying to get a anchor out before drifting away
from the spot you want to be at. Right now I'm using polly rope with
fair success.

Jerry

Someone wrote: "Nothing drives me crazy as fast as a knotted up rope when
trying to get a anchor out before drifting away
from the spot you want to be at."

I use to complain about the same thing. I now carry 200 feet of anchor rope
in my 19-foot bay boat since I fish areas with strong tides and large boat
traffic and the depth is up to 40 feet deep in some areas.. I store my
anchor rope on outdoor extension cord holders designed to hold 100 feet of
outdoor extension cord. They store very easy in a small storage bin on my
boat. I keep one hooked to the anchor and if I need more then 100 feet of
anchor line, I hook the two lengths together with a shackle. Both anchor
lines have spliced eyes on both ends. I attach a 5 foot chain to the anchor
and join the chain to the rope with a shackle.

Sarge

On Wed, 9 Jun 2004 20:14:12 -0500, "Sarge"
wrote:

Someone wrote: "Nothing drives me crazy as fast as a knotted up rope when
trying to get a anchor out before drifting away
from the spot you want to be at."

I use to complain about the same thing. I now carry 200 feet of anchor rope
in my 19-foot bay boat since I fish areas with strong tides and large boat
traffic and the depth is up to 40 feet deep in some areas.. I store my
anchor rope on outdoor extension cord holders designed to hold 100 feet of
outdoor extension cord. They store very easy in a small storage bin on my
boat. I keep one hooked to the anchor and if I need more then 100 feet of
anchor line, I hook the two lengths together with a shackle. Both anchor
lines have spliced eyes on both ends. I attach a 5 foot chain to the anchor
and join the chain to the rope with a shackle.

Sarge


So I ain't the only one with an extension cord reel holding my anchor
rode. Cool.