![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
You should have no problems. The only issue and it is a minor one is that
your batteries will be discharged unevenly. If you aren't running them almost all the way down before recharging there should be no problem what so ever. -- Public Fishing & Boating Forums Fishing & Boating Link Index www.YumaBassMan.com "Marty S." wrote in message ... I'm running 2 12-volt batteries running in series to power my 24-volt electric motor in my jon boat (on an electric-only reservoir) and I want to run a fish finder. Here's my question -- can I safely run the fish finder off of one of the 2 12-volt batteries while running the 24-volt motor? Or, is that going to burn up the fish finder? Should I just invest in a couple of 6-volt lantern batteries instead? -- Marty S. Baltimore, MD USA |
#2
|
|||
|
|||
![]() "Marty S." wrote in message ... I'm running 2 12-volt batteries running in series to power my 24-volt electric motor in my jon boat (on an electric-only reservoir) and I want to run a fish finder. Here's my question -- can I safely run the fish finder off of one of the 2 12-volt batteries while running the 24-volt motor? Or, is that going to burn up the fish finder? Should I just invest in a couple of 6-volt lantern batteries instead? The easiest way to hook them up so you will not have electrical interaction problems is to attach the negative wire of the fish finder to the same battery terminal as the negative wire of the trolling motor. That way both items use the same "ground" path. Bill Grannis service manager |
Thread Tools | |
Display Modes | |
|
|