![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() Bob La Londe wrote: "Ken Fortenberry" wrote in message m... Dan, danl, Redbeard uh Greybeard now wrote: "duty-honor-country" wrote: Snip ps- my spinning reel is a Shimano 4000 that handles up to 12 lb. line. I see absolutely no advantage to a baitcaster using 12 pound line in comparison, and a lot of aggravation from backlash tangles with the latter. ... snip Two, from your rantings I would place you in the troll catigory...The real poor skills, semi-intelegent dweeb type troll. I do not have to put forth anything more than your rantings to prove this point, you have done all the work for me. ... Damn man, that's harsh. Mr. d-h-c sounds to me like an opinionated old cuss looking for an argument. Kinda like a lot of fishermen I know. Usenet isn't very conducive to the kind of arguments that would seem perfectly OK when seated next to someone at the bar quaffing a brew. I'm willing to give Mr. d-h-c the benefit of the doubt and if I disagreed with him I'd argue it with him with a good nature and my tongue in cheek. But I tried to cast with my Dad's old Ambasseuder 5000 and never could get the hang of the damn thing, so I basically agree with Mr. d-h-c. 1/2 :-) Never had a 5000, but we had a bunch of 5000D models for catfishing and they were great. They could crank a catfish out of hole like a Warn winch pulling a Volkswagon out of a ditch. We could also cast them pretty accurately for distance when we took the time to adjust them for the weight of the lure used. I bet I could even pitch with one, but I'm not sure why I would want to. The size is the big hold up on that reel. Give me a low profile baitcasting reel anyday of the week for that. For the overhand guys... you can snap cast with a spinning rig too. You are not limited to big overhand casts. I side armed and did a variation of a circle cast with a spinning rod that I taught myself as a kid. It was the only way to get that precise placement I needed to drop spinners and spoons along weed edges when I was walking the Gila River. -- Bob La Londe www.YumaBassMan.com -- Ken Fortenberry exactly !! Fish a small stream in the thick woods and brush- you can forget overhead casting- it's all sidearm, and pulling loose line out to toss. good post |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cheapskate me.... Okuma Reel | Bob La Londe | Fly Fishing | 5 | September 12th, 2005 07:00 PM |
Ross Big Game Reel | Tim Carter | Fly Fishing | 4 | June 24th, 2004 04:42 AM |
Reel fishermen | allen | General Discussion | 1 | April 17th, 2004 05:04 AM |
FS: Diawa CV-X253A baitcasting reel | Glenn Ziolkowski | General Discussion | 0 | February 26th, 2004 02:55 AM |
FS: Diawa CV-X253A baitcasting reel | Glenn Ziolkowski | General Discussion | 0 | February 26th, 2004 02:55 AM |