![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
JR wrote:
- What colors and combinations of colors have you found effective for LMB? Same as for bass`poppers? Just in case Big Dale isn't lurking around, I'll toss out my thoughts on this. Be advised that I tend to fish on rivers, and as often as not, I'm targeting Guadalupe bass rather than largemouths. But, I do have experience with LMB. Colors are pretty much the same as poppers. It partially depends on what you're hoping to imitate. I tie them in frog colors (variations on green, brown, yellow and sometimes chartreuse is in the mix), and sometimes do them in all olive. Some folks like them in black. - If you're using several layers of thin foam instead of one thick piece, do you glue them together, or just rely on holding them together with thread wraps? Glue them together. The 3M adhesive spray (77?) is nasty stuff, but it works pretty well. You just have to figure out a way to weight things down without getting the glue all over everything. (Wax paper works pretty well as a barrier.) - What sort/sizes of hooks? In larger sizes, I've only got TMC 300s and 5263s but I suspect the shanks on these may be too long for gurglers. I use Mustad 3366 sizes 4 or 6, but if you're going after really big fish, you might even go up to size 2 or larger. |
#2
|
|||
|
|||
![]() Conan The Librarian wrote: JR wrote: - What sort/sizes of hooks? In larger sizes, I've only got TMC 300s and 5263s but I suspect the shanks on these may be too long for gurglers. I use Mustad 3366 sizes 4 or 6, but if you're going after really big fish, you might even go up to size 2 or larger. Ditto CTL's advice. I'd add using a wide gap, "bass bug" hook. Something like a Mustad 37187, TMC 8089, or Daiichi 2722. #4-#6 would be about right with the TMC and Mustad, but the Daiichi's are sized funny. I'd start with a 1/0 and work up from there. A friend of mine has some interesting versions of Gurglers. http://www.gurglersonline.com/ brians |
#3
|
|||
|
|||
![]()
On Mar 7, 9:05 am, Conan The Librarian wrote:
I use Mustad 3366 sizes 4 or 6, but if you're going after really big fish, you might even go up to size 2 or larger. For poppers and for bucketmouths, I'd say 4 or 6 was too small- with "too small" meaning the bluegill can get 'em in their mouths. I like to use something big enough that I won't be C&R'ing 10 'gills for every largemouth. The 'gills are just too fast and aggressive. So I like size 2. Except when my kids are fishing. Then something smaller. They don't seem to mind the "'gill on every cast" thing. :-) Hey, Chuck, I used that 3/4" dado plane yesterday. Very nice. Thanks again for being an enabler. :-) Bill |
#5
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gurgler Patterns? | Tony & Barb Vellturo | Fly Fishing | 37 | September 6th, 2004 03:41 AM |
bluegill Gurgler test | Joe McIntosh | Fly Fishing | 3 | June 8th, 2004 10:57 PM |
Gurgler swap | Stan Gula | Fly Fishing | 19 | May 26th, 2004 08:08 PM |
Gurgler swap | Stan Gula | Fly Fishing Tying | 17 | May 26th, 2004 08:08 PM |
Gurgler swap | Stan Gula | Fly Fishing | 0 | May 24th, 2004 09:10 PM |