![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Hi Derek,
Made my first trace tonight,needed magnifying glass to get the trace through the crimps and did not realise how much force those damn things needed, mind you I had to use long nose pliers as my normal pliers had a wide nose. Looks good and I tested the crimp as best I could without problem, well without problem to the crimp or hooks but not so for my fingers. So clumsy and blind ten.VBG Just got to test it on some un-expecting pike a couple of days. -- Gandalf "Derek Moody" wrote in message ... In article , Gandalf wrote: Going to get the trace kits tomorrow as I am off for a days dedicated pike fishing on Thursday. I think I will use a smelt or herring rather than bread though.(;-) Basically I will be buying enough to make 10 traces and spending £15 and I will not need more than ten traces this winter as pikeing will be done every other week I think. Enough to prove your technique and even to experiment a little, good idea. One trace you can't buy is a weighted sink and draw special - a 1oz bomb on the end, a strong single about 1" uptrace from it, a couple of trebles spaced according to the size of bait and an added twist wire loop above that. The trace needs to be a little longer than the conventional snap. In this case trebles are still probably best but I may experiment one day. In use put the bomb in the mouth of your deadbait and stitch the mouth closed with the single, bring the trace pack along the bait impaling at strategic points and then tie the wire to the tail with the twist loop. Cast the bait and it dives head first, wait half a minute, draw back to the surface and let it dive again .. and again. The action mimics a disabled but living fish so unlike static deadbaits pike take hard and you can strike relatively quickly knowing the hooks are in the right place. Don't use this with herring or mackerel - too soft. Scad, sand smelt or a dead roach are tougher. I am going to travel light so I can move round giving it half an hour in each swim. I have seen several pike into double figures in about 5 swims so I will have. The best 'groundbait' for a pike is a keepnet full of silver fish... floatfished on #8 hooks tied direct to 4lb reel line... I have had trout on floating bread before, as a kid we used to float a bit Sorry, maybe I wasn't too clear: floatfished - ie. under a float, rather than floating on the surface (though floating crust is a favourite bait of mine) - in this case a small quill carrying 6bb - a group and one bb as a telltale. I don't thing anyone else had much, most were sitting at slow, deep swims and I had all mine in streamy water under 3' deep. of crust under the old road bridge in Cricklade. It used to hammer through and then float in an eddy on the other side where it would be taken by almost anything that happened to be there. Great fun trying to pull it back through a mass of water doing 60 miles an hour as well. A 3 lb chub seemed more like a 20 lb pike. g Cheerio, -- Fishing: http://www.fishing.casterbridge.net/ Writing: http://www.author.casterbridge.net/derek-moody/ uk.rec.fishing.game Badge Page: http://www.fishing.casterbridge.net/urfg/ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how can i attract pike? | fishin' kid | General Discussion | 8 | August 10th, 2005 05:37 PM |
PIKE | Trond.Sundbakken | General Discussion | 0 | March 20th, 2005 10:35 PM |
pike | john calvert | UK Coarse Fishing | 2 | October 29th, 2004 04:55 PM |
Pike on a Fly | roadkill | Fly Fishing | 6 | April 10th, 2004 02:19 PM |
pike question | Phil.L | UK Coarse Fishing | 4 | October 13th, 2003 08:58 PM |