![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Dave LaCourse wrote:
On Sat, 3 May 2008 17:05:16 -0700, "Bob Weinberger" wrote: Even for those longer casts, a person rigged up as you describe is far better off using water loading rather than false casting to get the line out and reach the distance. The open looped slow line speed techniques required to false cast such rigs without tangles are not all that good for distance casting, and are next to impossible to execute effectively in the presence of wind. While I agree with the water loading, there are situations where I can not load the rod that way. One specific spot is a 50+ foot cast across a couple of currents, and the entire distance the fly travels is 25 feet and that is directly in front of me (and only half that distance is drag free). There is no way to water load the rod. The fly has to be retrieved (sometimes getting hits) before casting again. I disagree with your assertion that such fishing is not nymphing. Really. I run into this situation a lot: I have to make a pretty long cast across the current to reach the seam on the other side. I can't wade into a better position -- water's too deep and/or current's too strong. It's not an ideal situation, but it's all I have available. The only approach is to rig a heavily weighted nymph, false cast once or twice to get the distance, and then mend big upstream to get a few seconds of drift. I've caught a few fish that way. If I don't hook up I fish the swing. -- Cut "to the chase" for my email address. |
#2
|
|||
|
|||
![]()
On Sat, 03 May 2008 19:31:30 -0700, rw
wrote: The only approach is to rig a heavily weighted nymph, false cast once or twice to get the distance, and then mend big upstream to get a few seconds of drift. I agree. When I fish "Flat Top", I will also use dries for the long cast across the currents. Harry Mason's Killer Caddis is ideal for this spot. Upstream mend during the long cast, mend as soon as the fly hits, and I'll get a short drag free drift. When the currents overcome my mends, the fly will start to swing and I fish it wet. This fly is so versatile that I catch almost as many fish with it wet as I do dry. Dave |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why Dual Gas Tanks | Steveo | Bass Fishing | 5 | August 16th, 2007 02:32 AM |
Dual Fly Combos? | Padishar Creel | Fly Fishing | 14 | April 4th, 2007 04:08 PM |
Single or Dual Console? | Bubba | Bass Fishing | 13 | May 25th, 2005 03:45 AM |
Dual Sonar question... | Charles Summers | Bass Fishing | 13 | April 30th, 2004 02:45 AM |