|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
July 4th, 2008, 03:30 PM
posted to rec.outdoors.fishing.fly
|
|||
|
|||
Rod repair advice
On Jul 4, 3:32*pm, "Don Phillipson" wrote:
Traditional ferrule cement seemed not to adhere to IM6 graphite when I needed to replace a tiptop. Is there any reason not to use rubber cement? -- Don Phillipson Carlsbad Springs (Ottawa, Canada) . Most people use either five minute epoxy or hot melt glue. It is best to avoid glues and cements which contain various solvents, as many will attack the epoxy /carbon fibre (graphite) composite. This is especially dangerous on fine tips. TL MC http://www.mike1.bplaced.net/Wikka/HomePage 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Eye Repair | drwhittaker | Bass Fishing | 13 | May 9th, 2005 01:01 AM |
| Rod eye repair? | Marty | Bass Fishing | 3 | October 13th, 2004 12:41 AM |
| Rod repair | Paul M | UK Game Fishing | 0 | September 18th, 2004 08:03 AM |
| Repair Rod tip | FreddieM | Saltwater Fishing | 7 | July 18th, 2004 04:15 AM |
Threaded Mode