|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
September 30th, 2003, 03:38 PM
|
|||
|
|||
***** 2 PC. RODS***** Whats your take?
"Who Cares" wrote in message ... Any goods ones out there? ***I'm sure there are, but I haven't seen one yet. Would you buy one? ***The only way I'd have a two piece rod is if it was too long to fit into the rod locker. For me, that would have to be longer than 8 feet. What do you look for in one? ***Quality construction, good blank, built on the spine, tight fitting ferrule. Why are you considering a two piece rod? The two piece rods that I've seen always seem lacking in sensitivity and have a dead spot in the blank where the join is made. -- Steve OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode