fishing line memory

yes, thanks.
"Steve @ OutdoorFrontiers.com" wrote in message
...

"Paul Fisher" wrote in message
m...
The line spool edge was facing me with the line coming off the top and
onto the reel as if reeling in a fish. I have been hanging it by a bait
hook and letting the weight of the rod and reel pull down, and was going
to try a heat gun, but I will try the hot water and if no luck the
'walkabout' thanks

If I'm understanding you correctly, I know the problem right now. You
didn't put the line on backwards, you put it on "sideways!"

Like I said, mono line picks up a memory as it is stored on the filler
spool. The line takes a set as it's spooled and stored. It is important
that the line goes onto the reel spool in the same way that it lays on the
filler spool. The way you held the spool would have been perfect if you
were spooling a baitcasting reel, but with a spinning reel, the spool is
90 degrees perpendicular. So with each revolution of the bail, you were
putting a half twist in that segment of line. That all adds up to a mess
after spooling a hundred yards of line!

The next time you spool up your spinning reels, lay the spool down on the
floor, flat! Thread the line through the guides, open the bail and tie
the line to the spool. Now crank the reel handle two or three times.
Drop the rod tip and watch the line. Does it immediately twist up or
throw itself around the rod tip? If it does, now you're putting it on
backwards and need to flip the filler spool over. Now the line should
spool up nice and neat.

Make sense?
--
Steve Huber
Executive Producer/Editor in Chief
OutdoorFrontiers Multi-Media LLC
http://www.outdoorfrontiers.com

Let me say that it would be a good idea to read the reel's owner's manual,
or whatever sheet of paper that passes for a manual these days. Some reels
with anti-twist line rollers advise the user to spool it by holding the
supply spool the way you'd hold it for a baitcaster. I have both Daiwa and
Shimano reels which have such instructions.

In the absence of such instructions, lay the spool on the floor as Steve
suggests. I have never seen a spinning reel that doesn't put line on
clockwise, therefore, the supply spool should be on the floor such that the
line comes off it counterclockwise.

Finally, it may be that you are using line that just plain isn't
spinning-friendly and/or using line with too high a pound test for your
reel.


"Paul Fisher" wrote in message
...
yes, thanks.
"Steve @ OutdoorFrontiers.com" wrote in message
...

"Paul Fisher" wrote in message
m...
The line spool edge was facing me with the line coming off the top and
onto the reel as if reeling in a fish. I have been hanging it by a bait
hook and letting the weight of the rod and reel pull down, and was going
to try a heat gun, but I will try the hot water and if no luck the
'walkabout' thanks

If I'm understanding you correctly, I know the problem right now. You
didn't put the line on backwards, you put it on "sideways!"

Like I said, mono line picks up a memory as it is stored on the filler
spool. The line takes a set as it's spooled and stored. It is important
that the line goes onto the reel spool in the same way that it lays on
the filler spool. The way you held the spool would have been perfect if
you were spooling a baitcasting reel, but with a spinning reel, the spool
is 90 degrees perpendicular. So with each revolution of the bail, you
were putting a half twist in that segment of line. That all adds up to a
mess after spooling a hundred yards of line!

The next time you spool up your spinning reels, lay the spool down on the
floor, flat! Thread the line through the guides, open the bail and tie
the line to the spool. Now crank the reel handle two or three times.
Drop the rod tip and watch the line. Does it immediately twist up or
throw itself around the rod tip? If it does, now you're putting it on
backwards and need to flip the filler spool over. Now the line should
spool up nice and neat.

Make sense?
--
Steve Huber
Executive Producer/Editor in Chief
OutdoorFrontiers Multi-Media LLC
http://www.outdoorfrontiers.com

I am using Eagle Claw at 15 lb test,
"Marty" wrote in message
...
Let me say that it would be a good idea to read the reel's owner's manual,
or whatever sheet of paper that passes for a manual these days. Some reels
with anti-twist line rollers advise the user to spool it by holding the
supply spool the way you'd hold it for a baitcaster. I have both Daiwa and
Shimano reels which have such instructions.

In the absence of such instructions, lay the spool on the floor as Steve
suggests. I have never seen a spinning reel that doesn't put line on
clockwise, therefore, the supply spool should be on the floor such that
the line comes off it counterclockwise.

Finally, it may be that you are using line that just plain isn't
spinning-friendly and/or using line with too high a pound test for your
reel.


"Paul Fisher" wrote in message
...
yes, thanks.
"Steve @ OutdoorFrontiers.com" wrote in message
...

"Paul Fisher" wrote in message
m...
The line spool edge was facing me with the line coming off the top and
onto the reel as if reeling in a fish. I have been hanging it by a bait
hook and letting the weight of the rod and reel pull down, and was
going to try a heat gun, but I will try the hot water and if no luck
the 'walkabout' thanks

If I'm understanding you correctly, I know the problem right now. You
didn't put the line on backwards, you put it on "sideways!"

Like I said, mono line picks up a memory as it is stored on the filler
spool. The line takes a set as it's spooled and stored. It is
important that the line goes onto the reel spool in the same way that it
lays on the filler spool. The way you held the spool would have been
perfect if you were spooling a baitcasting reel, but with a spinning
reel, the spool is 90 degrees perpendicular. So with each revolution of
the bail, you were putting a half twist in that segment of line. That
all adds up to a mess after spooling a hundred yards of line!

The next time you spool up your spinning reels, lay the spool down on
the floor, flat! Thread the line through the guides, open the bail and
tie the line to the spool. Now crank the reel handle two or three
times. Drop the rod tip and watch the line. Does it immediately twist
up or throw itself around the rod tip? If it does, now you're putting
it on backwards and need to flip the filler spool over. Now the line
should spool up nice and neat.

Make sense?
--
Steve Huber
Executive Producer/Editor in Chief
OutdoorFrontiers Multi-Media LLC
http://www.outdoorfrontiers.com

"Paul Fisher" wrote in message
news
I am using Eagle Claw at 15 lb test,


That could be part of the problem. 15 pound test is pretty heavy line for
spinning tackle and I'm not sure what diameter the line is. Remember that
the larger the line's diameter, the less inclined the line will be to
conform to the spool and the more likely it will be to spring off the spool,
especially if you're using a smaller spinning reel with a smaller diameter
spool. The heaviest line I'll ever use on a spinning reel is 12 pound, and
usually I'm using 4 to a max. of 10 pound.
--
Steve Huber
Executive Producer/Editor in Chief
OutdoorFrontiers Multi-Media LLC
http://www.outdoorfrontiers.com

"Steve @ OutdoorFrontiers.com" wrote in message
...

"Paul Fisher" wrote in message
news
I am using Eagle Claw at 15 lb test,


That could be part of the problem. 15 pound test is pretty heavy line for
spinning tackle and I'm not sure what diameter the line is. Remember that
the larger the line's diameter, the less inclined the line will be to
conform to the spool and the more likely it will be to spring off the
spool, especially if you're using a smaller spinning reel with a smaller
diameter spool. The heaviest line I'll ever use on a spinning reel is 12
pound, and usually I'm using 4 to a max. of 10 pound.

I use 12lb flourcarbon on one of my spinning reels and its always a
challenge. I've found the best thing I can do (if I remember) is to respool
when I came back in from fishing and let the reel sit for a couple days
rather than respooling the night before. That isn't always an option.
Blakemoore Reel Magic sprayed on the line helps a little, but not as much as
just letting set on the reel for a couple days.

In the absence of such instructions, the spool of Steve lying on the floor recommendations. I've never seen a spinning reel, not the line clockwise direction, therefore, the supply spool to be on the floor, making counterclockwise line off.