Gettin' ready

On Jan 4, 8:40*pm, Giles wrote:
On Jan 4, 8:30*pm, Frank Reid © 2008 wrote:

I make my own loop in the line using a heat gun and a piece of shrink
tube. *Very cool technique.
Shave half the coating down to the core on about 1" of the end of the
fly line. * Slide a three inch long piece of shrink tube over the
line, below the shaved part. *Push the shaved part inside the shrink
tube leaving a loop of unshaved fly line outside the tube.
Put a heat gun on low, and shrink the shrink tube down, moving fully
around the tube. *Let cool for about 30 seconds.
Cut off the shrink tube. *If you've done it right, you melt the
coating back on itself, leaving a strong loop.
Frank Reid

And if you've done it wrong?

You get published. * * * *

giles
hey, am i right, or am i wrong?

Thhhhhhttttttt!!!!!!!!!!!!!
Frank Reid