|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 5th, 2003, 12:11 AM
|
|||
|
|||
Advice needed for problem with Itasca neoprene waders
Hello all:
First let me say that I'm new to fishing news groups but have been a UseNet poster for almost 20 years... I surf fish in NJ.. Striped Bass, Bluefish, Little Tunnies, Spanish Mackerel, etc. Last year I replaced an old pair of Ball Waders with Itasca neoprene waders. I have run into a problem and am looking for some advice. Where the boot meets the legging, the rough surface causes severe chaffing on my calves making them too painful to wear. Does anybody have any ides that I can apply to smooth over the boot-legging junction such that don't chafe my legs ? TIA Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| waders rant | Steve Sullivan | General Discussion | 50 | January 6th, 2005 10:27 PM |
| waders rant | Steve Sullivan | Fly Fishing | 66 | January 6th, 2005 10:27 PM |
| Landing Bass through THICK! Milfoil/Vegetation - Advice Needed | J.P. | Bass Fishing | 15 | May 26th, 2004 05:57 PM |
| horrible experience with mercury outboard - advice needed! | J.P. | Bass Fishing | 5 | May 18th, 2004 08:32 PM |
| Advice needed for problem with Itasca neoprene waders | David H. Lipman | General Discussion | 4 | October 6th, 2003 07:12 PM |
Threaded Mode