A Fishing forum. FishingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » FishingBanter forum » uk.rec.fishing newsgroups » UK Coarse Fishing
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Can one rod cover all lure requirements?



 
 
Thread Tools Display Modes
  #1  
Old February 10th, 2004, 09:14 PM
Goldeneye
external usenet poster
 
Posts: n/a
Default Can one rod cover all lure requirements?

?????????????????????

Sounds like some interesting advice below!!!

The simple answer is NO!! One rod will not do all of these things - But you
do not want one that will - at least not yet.

I would suggest that you go with a short rod, assuming that you can get
close to the margins at the venues you will be fishing. A short rod is far
easier than a longer rod for holding all day (ie a 6' rod). Ideally one
that will handle lures up to 1 oz. This can then be combined with a
smallish fixed spool reel and 15lb mono, or 25lb braid (reccomended). I
would strongly advise against getting a carp rod as you will end up with
tired shoulders and a bad back if you use that for a day!

If you want to start using the bigger jerkbaits/crankbaits, you will need to
get a specialist rod (again normally about 6'), and a multiplier reel.
These take some getting used to as you have to impart the action into the
lure - I would not reccomend them for a beginner to lure fishing.

For some articles about fishing, a friend of mine has a site with some
sections about lure fishing http://www.elyroswell.co.uk/ there is a pic of
me with a 13lb fish caught on a creek chub pikie on there too!

It is also worth looking at http://www.harrisangling.co.uk as they
certainly had some really good rods on a genuine half price offer until
recently (they may still, I have not looked lately). A warning though -
Their half price bargains of the day are addictive!

If you want any more info let me know.

Good luck - It is good fun catching fish on lures!

...
spamless wrote:
: Dear all,
:
: I am just getting into lure fishing for Pike and find the range of
: rods and lures bewildering. Being a firm believer in the adage "tackle
: catches Anglers - not fish", I would appreciate some assistance with
: the following;
:
: There is a massive range of lure weights, most pike type lures I have
: seen range from 1 to 6 Ozs, my question is "can one rod realistically
: be used to cover this whole range".

Then you havent been looking hard enough, I have dozens of pike lures and
the heaviest is less than an ounce.


: I have seen rods advertised that claim to cover 1 to 6 Oz, does
: anybody have any experience of these. I cannot see that a rod with
: the backbone to haul a 140 grams lure isn't too stiff to be of any
: use when using a 28 grams lure. This is based on my fly fishing
: experience where you cannot correctly cast a five weight line with a
: ten weight rod and vice versa.

Pike fishing is nothing at all like fly fishing.
You dont need to be able to cast a six ounce weight ! - I can easily cast

a
one ounce spinner a hundred yards using a carp rod, which is plenty far
enough IMV.
Also pike will take dead bait, and also plugs, which are very light and

you
need something for this type of angling more than the broom handles

required
to launch half a pound to the opposite bank.
:
: I cannot afford to buy multiple rods but it seems to me that two rods
: would give the best versatility and would ensure that for the smaller
: lures I am not trying to cast them with a broom handle.
:
: My idea is to get say a 20 to 60 grams long rod (9 foot) and a 60 to
: 110 grams short rod (6 to 7 foot).
:
: Most fishing would be river / reservoir from bank or boat.
:
: Does this sound sensible or have a missed something?

Yes, if your fishing from a boat, you dont need to cast at all.
If you've never fished for pike before, get yourself a cheap carp rod with

a
2.5lb test curve, this will easily cast up to 2oz lures which is ample
unless you're hoping to catch dolphins!




  #2  
Old February 11th, 2004, 12:16 AM
Derek.Moody
external usenet poster
 
Posts: n/a
Default Can one rod cover all lure requirements?

In article , Goldeneye
wrote:

Re-ordered to convention and heavily snipped:

...
spamless wrote:


: There is a massive range of lure weights, most pike type lures I have
: seen range from 1 to 6 Ozs, my question is "can one rod realistically
: be used to cover this whole range".

Then you havent been looking hard enough, I have dozens of pike lures and
the heaviest is less than an ounce.


Which isn't a lot of use for spinning beneath heavy water. 6oz is a bit OT
for out and out lures but a deadbait on a sink and draw mount might weigh
nearer a pound.

: I have seen rods advertised that claim to cover 1 to 6 Oz, does
: anybody have any experience of these. I cannot see that a rod with
: the backbone to haul a 140 grams lure isn't too stiff to be of any
: use when using a 28 grams lure. This is based on my fly fishing
: experience where you cannot correctly cast a five weight line with a
: ten weight rod and vice versa.


And you can cast fluffy lures to pike on a fly rod too.

Don't imagine you are in the distance casting business. Even a carp rod
will lob a half-pound deadbait 20 or so yards. You rarely need to cast
farther and if you do you'll have trouble setting the hooks.

Pike fishing is nothing at all like fly fishing.
You dont need to be able to cast a six ounce weight ! - I can easily cast

a
one ounce spinner a hundred yards using a carp rod, which is plenty far
enough IMV.


Far too much. Accurate casting at 20 yards is more sense than 100 yard
blasts.

: My idea is to get say a 20 to 60 grams long rod (9 foot) and a 60 to
: 110 grams short rod (6 to 7 foot).
: Most fishing would be river / reservoir from bank or boat.


What are the banks like? These might be OK from a boat or a bare bank but
for any natural bank with overhanging cover you'll need a bit more length.
A cheap, second hand last-year's deeesigner-special cap rod of about 11 - 12
feet is a good start. You might want to shorten the butt with a hacksaw,
take care to cover the raw end somehow..

close to the margins at the venues you will be fishing. A short rod is far
easier than a longer rod for holding all day (ie a 6' rod). Ideally one
that will handle lures up to 1 oz. This can then be combined with a
smallish fixed spool reel and 15lb mono, or 25lb braid (reccomended). I
would strongly advise against getting a carp rod as you will end up with
tired shoulders and a bad back if you use that for a day!


Never noticed it. On a lot of the banks I fish you will be continually
tangled and frustrated with a short rod. With a long rod you can often lob
a plug into a tight corner where a short one would need a full cast and be
less accurate.

Good luck - It is good fun catching fish on lures!


Now this I can agree with :-)

Cheerio,

--


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Discount Fishing Magazines Shannon Still General Discussion 0 March 7th, 2004 09:27 PM
Quacks like a lure Salmo Bytes Fly Fishing Tying 1 February 28th, 2004 10:25 PM
Can one rod cover all lure requirements? spamless UK Game Fishing 1 February 11th, 2004 12:27 AM
Seagull retrieved me lure for me Jimmy Reza de la Turin Bass Fishing 5 January 17th, 2004 11:04 PM
lure? Gone Angling Bass Fishing 2 November 14th, 2003 03:34 PM


All times are GMT +1. The time now is 05:08 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 FishingBanter.
The comments are property of their posters.