![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
In article ,
"GeneS" wrote: I'm installing new PowerPro 30# line on all my reels today. I mostly fish for sal****er trout, reds, & flounder in the Gulf Coast bays, and bass in the freshwater lakes. Question: I have heard that it is a pain to tie the PowerPro line. Is there a "Snap-Swivel" out there that I can use that will allow me to test different lures, etc. - without scaring off the fish? Once I have found the lure, etc. that I want to use, I can tie it to another rod & reel less the snap-swivel. If so, what size & brand of snap-swivel? I have never been really clear on this subject. I have used snap-swivels on lures in both salt & fresh water & caught fish. Then again, I really do not know how many I lost either:-) If anyone has ever seen good scientific data on the subject, please post a link here. THANKS, Gene If you are going to use (already have) additional reels I suggest just tying on a few various lures to the additional rods. I started out with a couple of rods and now carry about 5 - 6 on a trip. I always have a johnson spoon (silver is my preference), topwater (walk or chug/pop), jerkbait, sub-surface lure and a couple other options. This is for flats fishing which I guess would be similar to what you are doing. If you are not tying on a leader (fluorocarbon is a good bet) then the braided lines are really not too much trouble to tie. Following the mfg. suggestion to use enough wraps and maybe double the line it is not too hard. The slippery nature of the lines help them snug up easily and since they are strong and small they make a pretty compact knot. Using a leader I use the uni to uni, doubling the braid and making about 8 - 9 wraps then just use the typical 3 - 4 for the 20 - 30 pound leader. I do hate to try to tie this any more than needed so I usually add about 30 inches of leader to give room to re-tie. Of course if you get into a snook (or even ladyfish) you may have to replace the leader anyway from the abrasion. I use a swivel with my spoon and have not noticed any shyness on the part of the reds that I have caught. I do not imagine that tying on a swivel would be a huge deterrent to getting strikes. I have thought about using a swivel between the braid and the leader. The biggest problem with this is that the swivel will not go through the guides or possibly could damage your tiptop guide. The other issue with using a snap swivel with your terminal tackle is that it will likely change the action and balance of the lure you are trying. Lastly, it is another possible point of failure. I have preferred using the ball bearing swivels but have had failures even with some of the 'better' brands. Overall I would suggest just tying on your lure other than something that requires a swivel to avoid line twist (like a spoon). Good Fishin' atljoe -- "Atlanta Joe" aka Joe Webb Flats fishing is Flat Fun! Visit my site at http://flatsfisher.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Does a "Snap-Swivel" really reduce the number of strikes? | GeneS | Bass Fishing | 7 | July 7th, 2004 01:57 AM |
Snap swivels (power pro line is tangling). | CR | Bass Fishing | 3 | October 4th, 2003 01:16 PM |