![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I would think seriously about launching a pontoon craft in a sal****er
situation that has any potential major current. If you are in a large sal****er bay that's one thing, but in a tide flowing scenario you could easily get into trouble. For example, a place I take clients is the mouth of Barnstable Harbor on Cape Cod, MA. The flats have moderate current on outgoing tides but the main channel is major and no amount of fin paddling is going to work. Just be careful, check out the tides wherever you decide to go and scope it out thoroughly first. No fish is worth drowning for. Good fishing...Ted |
#2
|
|||
|
|||
![]()
In article ,
"Ted Bobetsky" wrote: I would think seriously about launching a pontoon craft in a sal****er situation that has any potential major current. If you are in a large sal****er bay that's one thing, but in a tide flowing scenario you could easily get into trouble. For example, a place I take clients is the mouth of Barnstable Harbor on Cape Cod, MA. The flats have moderate current on outgoing tides but the main channel is major and no amount of fin paddling is going to work. Just be careful, check out the tides wherever you decide to go and scope it out thoroughly first. No fish is worth drowning for. Good fishing...Ted I have seen a few of these type craft in sal****er (very few) but I think you would do much better with a kayak or canoe. For the canoe you can start with something stable (though there are always compromises) and then add outrigger stabilizers (Spring Creek as I recall is a vendor). You can certainly get where you are going quicker and cover more water. For the kayak you could use the same formula as you can add the outriggers to them as well. I use a Hobie Outback with a pedal system and I have yet to see a current that it could not handle (of course I am not fishing in the NE either). I have come through Longboat Key near Sarasota Fl at full outgoing tide though. Another option for a kayak that will allow you to stang is the Tribalance (I have one of those also). It will not capsize but that does not mean you can not fall out. It also offers the option of sitting inside in inclement weather as you get in or out but also on top. An easy rise to your feet to make a cast. There was one fellow off one of the central FL beaches fishing for tarpon from an intertube (good size hammers are seen there also); they nicknamed him 'bait' good luck! Atlanta JOE -- "Atlanta Joe" aka Joe Webb Flats fishing is Flat Fun! Visit my site at http://flatsfisher.com |
#3
|
|||
|
|||
![]()
joe wrote:
For the kayak you could use the same formula as you can add the outriggers to them as well. I use a Hobie Outback with a pedal system and I have yet to see a current that it could not handle (of course I am not fishing in the NE either). I have come through Longboat Key near Sarasota Fl at full outgoing tide though. I also use the Hobie OutBack,, This has got to be the best, light, take anywhere boat, out there, yes I know it's the most expensive, but it comes fully loaded for fishing, I take it out 10 to one over my bass boat now, not only in skinny water either. It's just FUN to fish from. I can see a huge problem with it this summer though,, keeping the wife, kids and grand kids out of it, so I can use it fishing. This little problem will help many men get permission to buy it though . "Look Honey , you, and the kids, will use it more than me" :-) I'm in the process of doing a complete web page, product review, on the boat, I should have it finished this weekend, and get it up on my web site. I just wish it had a reverse, besides the paddle that is -- Rodney Long, Inventor of the Boomerang Fishing Pro. , Stand Out Hooks , Stand Out Lures, Mojo's Rock Hopper & Rig Saver weights, Mojo's Long Shot rig and the EZKnot http://www.ezknot.com |
Thread Tools | |
Display Modes | |
|
|