|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
September 27th, 2004, 10:58 PM
|
|||
|
|||
Fly Rod Guide Wraps and Cracked Epoxy
snip
http://www.rodbuilding.org/read.php?...15161&t=115161 /snip Stephen "Lat705" wrote in message ... In answer to the cracking prolem: Sure you aren't using too much hardener? The hardness (modulus ) usually increses with the amount of hardener. For the engineers: Modulus is portional to cure agent to polymer ratio. Lou T 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode