Attaching a fighting butt?

On 30 Aug, 06:54, wrote:

You can buy the necessary stuff here;

http://www.jannsnetcraft.com/rod-building/

It is not very expensive.

You might also like to have a look at the PFLUEGER TRION IM8 GRAPHITE
FLY RODS, the 8/9 model comes with a detachable fighting butt.

http://www.hookhack.com/flyrods.html

Not much more than the three forks you were considering, and already
set up.

TL
MC

http://www.mike-connor.homepage.t-online.de/

In case it was not entirely clear why the first butt shown is
detachable, that is because the butt can be a real nuisance when
casting. The butt is only attached when one hooks a fish, This is
easy and quick to do, and causes far fewer problems than a permanently
attached butt. I carry the butt in a side pocket of my jacket. It only
takes a second or two to shove it in when required.

Also, I have made a few of these for people who wanted ultra light
spinning rods, but still wanted to use the rod as a fly rod.

One or two people also wanted to use a few rods as light Spey rods,
but still revert to single handed casting when desired. There are a
number of reasons for these extensions.

MC

http://www.mike-connor.homepage.t-online.de/

"Mike" wrote in message
ups.com...
In case it was not entirely clear why the first butt shown is
detachable, that is because the butt can be a real nuisance when
casting. The butt is only attached when one hooks a fish, This is
easy and quick to do, and causes far fewer problems than a permanently
attached butt. I carry the butt in a side pocket of my jacket. It only
takes a second or two to shove it in when required.

Also, I have made a few of these for people who wanted ultra light
spinning rods, but still wanted to use the rod as a fly rod.

One or two people also wanted to use a few rods as light Spey rods,
but still revert to single handed casting when desired. There are a
number of reasons for these extensions.

MC

http://www.mike-connor.homepage.t-online.de/



I once had a Winston LT 9' 7wt. with a detachable fighting butt. Winston
used
a double o-ring pressure fit to secure it into the reelseat. I found it to
be more of a nuisance then a helpful assistant. I ended up putting the
standard cap back on, which
was the same pressure fit. Eventually sold the rod, and never thought of
ever owning
a 5pc sectional again.

Most of the rods companies have fighting butts rods from 7wt & up. I have
the TFO Professionals in a 8wt & 10wt ("w/secured" fighting butts) ...fairly
inexpensive rods, but they get the job done, as I have used them in Alaska
the last two years. Personally I would not want to hook up with a King
Salmon on a river without a fighting butt.
-tom

"Mike" wrote in message
ups.com...
Sorry, I forgot quite an important point. If you do use wood, then it
should be very hard wood, and extremely well sealed. ( soaked in warm
epoxy and then finished when dry), as otherwise it may swell when it
gets wet, and either be impossible to remove, or even damage the
blank.

I believe the technical name is "stabilized wood"
There are plenty of websites who specialize in such, or you can do as
Mike says above.
-tom