![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#41
|
|||
|
|||
![]()
A wide gap hook can 'rotate' out more easily. A the shank gets in the way
of rotating out on a narrower gap hook. It has to BACK out rather than rotate out. A wide gap can do either. As far as setting goes, amplify the effect to see it clearly. Take your wide gap hook on really strong line, and put the tip of it against something it doesn't want to penetrate easily. Eg, a piece of soft wood. Pull slowly and watch the bend in the hook open up. Do the same with a narrow gap hook of the same size. Note how much harder you have to pull to open the bend. With a wide gap hook, the only solution to the hook's tendency to open up is heavier wire (EG, Gamakatsu Super ine EWGs.) But thicker wire increases the penetration resistance, so it's still harder to set. We've run this thing through computer modeling and real world tests till we're sick of it. The best hook design from a standpoint of hooking fish and staying hooked is a moderate gap with a sharp turn leading to a longer than average length of wire between the bend and the barb. RichZ© www.richz.com/fishing |
#42
|
|||
|
|||
![]()
On Sat, 17 Jul 2004 20:37:04 EDT, RichZ wrote:
We've run this thing through computer modeling and real world tests till we're sick of it. The best hook design from a standpoint of hooking fish and staying hooked is a moderate gap with a sharp turn leading to a longer than average length of wire between the bend and the barb. RichZ© www.richz.com/fishing Sounds an awful lot like a Texposer to me... Harry J aka Thundercat Brooklyn Bill's Tackle Shop Fishing Team http://www.geocities.com/brooklynbill2003/products.html Share the knowledge, compete on execution. |
#43
|
|||
|
|||
![]()
On Sat, 17 Jul 2004 20:37:04 EDT, RichZ wrote:
We've run this thing through computer modeling and real world tests till we're sick of it. The best hook design from a standpoint of hooking fish and staying hooked is a moderate gap with a sharp turn leading to a longer than average length of wire between the bend and the barb. RichZ© www.richz.com/fishing Sounds an awful lot like a Texposer to me... Harry J aka Thundercat Brooklyn Bill's Tackle Shop Fishing Team http://www.geocities.com/brooklynbill2003/products.html Share the knowledge, compete on execution. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fishing Hooks | Bill Kiene | Fly Fishing | 23 | June 30th, 2011 01:24 AM |
Magnetic hooks | vincent p. norris | Fly Fishing Tying | 11 | March 18th, 2004 06:40 AM |
Rusting hooks | SHRED© | Bass Fishing | 4 | March 9th, 2004 12:00 AM |
Gamakatsu Fly Tying Hooks - Opinion | Cornmuse | Fly Fishing Tying | 3 | February 20th, 2004 04:08 AM |
hooks? | Rodney | General Discussion | 0 | October 22nd, 2003 07:22 PM |