![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
My spinning reel is broken. I have had it for less than one season and
the retrieve is seized up. I'm going to find the address and send it back to the manufacturer under warranty. I assume there is at least a one year warranty on it. It is beyond 90 days so the retailer won't take it back. Also I have a question. I like to slow retrieve my lures what gear ratio in a spinning reel should i look for to accomplish it in the easiest manner. Some reels you barely move the handle and the lure speeds up too fast or you can't judge the spped of the lure.. |
#2
|
|||
|
|||
![]()
fishtale wrote:
My spinning reel is broken. I have had it for less than one season and the retrieve is seized up. I'm going to find the address and send it back to the manufacturer under warranty. I assume there is at least a one year warranty on it. It is beyond 90 days so the retailer won't take it back. Also I have a question. I like to slow retrieve my lures what gear ratio in a spinning reel should i look for to accomplish it in the easiest manner. Some reels you barely move the handle and the lure speeds up too fast or you can't judge the spped of the lure.. Are you a troll or really that stupid? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pflueger reels | [email protected] | Fly Fishing | 4 | May 28th, 2005 06:03 AM |
Tica Reels? | Steve @ OutdoorFrontiers | Bass Fishing | 18 | October 17th, 2004 07:15 PM |
adg fly rods and reels?? | steve sullivan | General Discussion | 24 | March 26th, 2004 06:27 AM |
adg fly rods and reels?? | steve sullivan | Fly Fishing | 26 | March 26th, 2004 06:27 AM |
ot casting reels | Gone Angling | Bass Fishing | 22 | January 3rd, 2004 06:45 AM |