![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
My trolling motor batteries will only last about an hour on medium
speed, they use to go for hours, could a lack of water cause them to discharge faster? how much water should be in them? should I add water if needed. matthew 4:19 follow me and I will make you fishers of men. |
#2
|
|||
|
|||
![]() "BIG FISH 2006" wrote in message ... My trolling motor batteries will only last about an hour on medium speed, they use to go for hours, could a lack of water cause them to discharge faster? how much water should be in them? should I add water if needed. You need to add distilled water or battery electrolyte solution to the batteries and make sure that the lead cells are completely covered with water. Even "maintenance free" batteries need to be checked periodically. I typically check my batteries once a month and top off as needed. The batteries you have now are quite possibly cooked and won't hold a charge well any longer and will probably need replacement. -- Steve @ OutdoorFrontiers http://www.outdoorfrontiers.com G & S Guide Service and Custom Rods http://www.herefishyfishy.com |
#3
|
|||
|
|||
![]()
What Steve said and that's what happened to me + make sure your charging
cables are secured tightly to the batteries if you have an onboard charging system. If they are loose you will not get a full charge to begin with. -- God Bless America Josh The Bad Bear |
#4
|
|||
|
|||
![]()
On Tue, 7 Aug 2007 10:37:13 -0500, "Joshuall"
wrote: What Steve said and that's what happened to me + make sure your charging cables are secured tightly to the batteries if you have an onboard charging system. If they are loose you will not get a full charge to begin with. Yeah, add distilled water or electrolyte solution..........same thing huh Steve..........MORON. I suggest you force SPAM in there. You need an onboard spam fryer and a boat helper. If you had a boat helper , you could just lay back and smell eggs and spam frying. I think Steve is selling boat helpers at a discount price, by golly! What's your website again Steve for those boathelpers you're selling, by golly? |
#5
|
|||
|
|||
![]()
On Aug 5, 7:22 pm, (BIG FISH 2006) wrote:
My trolling motor batteries will only last about an hour on medium speed, they use to go for hours, could a lack of water cause them to discharge faster? how much water should be in them? should I add water if needed. matthew 4:19 follow me and I will make you fishers of men. Hello, This is my first post to the group, Hello All. All batteries, even deep cycle marines, have a limited number of recharge cycles they can go through. Usually, a good battery will indicate how many cycles it can go through before it degrades to less than %70 or so of it labeled capacity. With each charge-dicharge cycle the battery's capacity is actually deminished becuase of the formation of Type III Lead Sulfate Crystals that do not re-dissolve from the plates when it recharges. This substance is alsot the reason why it is CRITICAL that the battery be recharged within 12 to 24 hours, as the Type I and Type II lead sulfate will turn into Type III given enough time. Also, for maximum life, and the get the cycle count as the mfg. indicates, even a deep cycle battery should only be brought down to 50% of its total charge becuase formation of Type III Lead sulfate becomes more and more dominate as the battery charge lowers. As far a maintenace is concerned it depends on the type of battery you have. Gell Cell batteries are usually sealed and do not require any water or acid additions. Sealed Lead Acid batteries also do not require anything as well Both of these type are assuming you have a good three stage battery charger that does a bulk charge, and topping charge, and a float charge. Normal, dumb, chargers can and usually do charge too fast and too long, leading to boil over, bloating, and incremental plate damage. For regulat or flooded batteries be sure to use DISTILLED water as the replacement electrolyte in the battery. Anything else can, and most likley will, contaminate the solution and that is very bad. Also, you shouldn't need to ever add more acid to the battery unless it has boiled over or spilled out. Is there a solution to this? Perhaps, sometimes Pulse chargers seem to reverse some sulfate damage. Note! You should never just leave a battery sitting without a float charger on it. All batteries self-discharge over time and that problem with sulfating rears its ugly head. Higher temperatures make it happen a lot faster! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
trolling motor batteries replacement | Ken Blevins | Bass Fishing | 6 | June 15th, 2006 05:29 PM |
Motor Guide trolling motor | IBNFSHN | Bass Fishing | 0 | February 16th, 2005 03:59 PM |
Trolling batteries, same make & model, different year | Jamie Jackson | Bass Fishing | 10 | December 30th, 2004 02:53 AM |
Batteries for trolling motor on a jon boat..>>> | Marty S. | General Discussion | 17 | May 6th, 2004 09:33 PM |
Batteries for trolling motor on a jon boat..>>> | Marty S. | Bass Fishing | 17 | May 6th, 2004 09:33 PM |