A Fishing forum. FishingBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » FishingBanter forum » rec.outdoors.fishing newsgroups » Bass Fishing
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

cleaning carbs



 
 
Thread Tools Display Modes
  #1  
Old December 26th, 2006, 07:23 PM posted to rec.outdoors.fishing.bass
BIG FISH 2006
external usenet poster
 
Posts: 162
Default cleaning carbs

can cleaning your carbs help your motor start faster? I have a 1997
johnson 200 hp venom, and its takes about 4-5 times for it to start up
and run, by that time it smokes like crazy until the fuel and oil burns
off.

  #2  
Old December 27th, 2006, 12:37 AM posted to rec.outdoors.fishing.bass
Ronnie
external usenet poster
 
Posts: 549
Default cleaning carbs

I had one of those - it was the motor that locked up at the 2002 MTC.
Mine was always cold natured the first time I cranked it but was fine
after the first time. Had to choke it hard the first time and the
excess fuel and oil did smoke a lot burning off, but after that it did
not smoke.

Changing plugs helped when mine got real bad.

Ronnie
fishing.about.com
http://fishing.about.com

BIG FISH 2006 wrote:
can cleaning your carbs help your motor start faster? I have a 1997
johnson 200 hp venom, and its takes about 4-5 times for it to start up
and run, by that time it smokes like crazy until the fuel and oil burns
off.


  #3  
Old December 27th, 2006, 12:56 AM posted to rec.outdoors.fishing.bass
Carlos
external usenet poster
 
Posts: 18
Default cleaning carbs

BIG FISH 2006 wrote:
can cleaning your carbs help your motor start faster? I have a 1997
johnson 200 hp venom, and its takes about 4-5 times for it to start up
and run, by that time it smokes like crazy until the fuel and oil burns
off.

You might already know this, but.

Be sure to trim it all the way down when starting. Carbs work better
when the fuel mix is going down the throat of a carb and not having to
go uphill.

Carlos
  #4  
Old December 27th, 2006, 04:43 AM posted to rec.outdoors.fishing.bass
BIG FISH 2006
external usenet poster
 
Posts: 162
Default cleaning carbs

when I start it and it dies, then I restart should i push the choke back
in slowly or hold it in for a few seconds if it starts to die again?

  #5  
Old December 27th, 2006, 09:58 AM posted to rec.outdoors.fishing.bass
Huck P
external usenet poster
 
Posts: 27
Default cleaning carbs

...at'tl work. I've got a 1990 150GT which does the same thing. Clears out
the mosquitos when it first starts, but then it's fine for the rest of the
day. May not be "normal", but it's typical for my three carburetors. said
Huck

"BIG FISH 2006" when I start it and it dies, then I restart should i push
the choke back
in slowly or hold it in for a few seconds if it starts to die again?



  #6  
Old December 27th, 2006, 02:30 PM posted to rec.outdoors.fishing.bass
Ronnie
external usenet poster
 
Posts: 549
Default cleaning carbs

BIG FISH 2006 wrote:
when I start it and it dies, then I restart should i push the choke back
in slowly or hold it in for a few seconds if it starts to die again?


I always had to hold my choke in until the motor caught up and ran
smoothly. Not sure what kind of choke you have - mine I pushed the key
in to activate the choke - it was closed or open, no slowly pushing it
in.

Ronnie

http://fishing.about.com

  #7  
Old December 27th, 2006, 04:01 PM posted to rec.outdoors.fishing.bass
Bob La Londe
external usenet poster
 
Posts: 1,009
Default cleaning carbs

"Ronnie" wrote in message
ups.com...
BIG FISH 2006 wrote:
when I start it and it dies, then I restart should i push the choke back
in slowly or hold it in for a few seconds if it starts to die again?


I always had to hold my choke in until the motor caught up and ran
smoothly. Not sure what kind of choke you have - mine I pushed the key
in to activate the choke - it was closed or open, no slowly pushing it
in.


Sounds like he may have been reffering to the fast idle control instead of
the choke, or don't Johnsons have a fast idle lever?


--
Bob La Londe
Fishing Arizona & The Colorado River
Fishing Forums & Contests
http://www.YumaBassMan.com





--
Posted via a free Usenet account from http://www.teranews.com

  #9  
Old December 27th, 2006, 10:22 PM posted to rec.outdoors.fishing.bass
BIG FISH 2006
external usenet poster
 
Posts: 162
Default cleaning carbs

I'm sorry Ronnie, I didn't explain the choke right, my boat is a 1997
Javelin 400 TE it has the choke plunger on the key. What it sounds like
is that I need to keep that pushed in until its running smooth? I alway
let it out as soon as it fires, then it stalls and I keep restarting it
till it runs. By me restarting 3-4 times I think is where I'm getting
all the smoke.

Big Fish

  #10  
Old December 28th, 2006, 12:59 AM posted to rec.outdoors.fishing.bass
Ronnie
external usenet poster
 
Posts: 549
Default cleaning carbs


BIG FISH 2006 wrote:
I'm sorry Ronnie, I didn't explain the choke right, my boat is a 1997
Javelin 400 TE it has the choke plunger on the key. What it sounds like
is that I need to keep that pushed in until its running smooth? I alway
let it out as soon as it fires, then it stalls and I keep restarting it
till it runs. By me restarting 3-4 times I think is where I'm getting
all the smoke.

Big Fish


Yes - hold it in. When you release the key the choke opens up
completely and there is no choke. Hold it in till the motor is running.
If you release it and it starts to sputter push it back in. I often had
to hold mine in 15 seconds or more till it started running smooth.

I think that will cut out some of your smoke, too.

Mine was on a 295 Stratos - similar to the Javelin. I also had a 94
Javelin 400 TE later but had a 2001 Johnson 225 on it. It did not need
the choke anything like the 97 Venom did.

Ronnie

http://fishing.about.com

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Cleaning Deer tails Kevin Fly Fishing Tying 5 July 14th, 2004 12:34 AM
Fish cleaning kit with video? B. Jones Bass Fishing 12 April 16th, 2004 03:39 AM
Advice? Cleaning up an old fly rod.. Mike Makela Fly Fishing 3 April 4th, 2004 11:19 PM
cleaning 200&201 curado kenneth blevins Bass Fishing 3 December 19th, 2003 10:42 AM
cleaning catfish Lone Haranguer Catfish Fishing 5 October 22nd, 2003 07:38 PM


All times are GMT +1. The time now is 07:54 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 FishingBanter.
The comments are property of their posters.